T-ONE Model: T1-2024AA and T1-2024C
T*One is Wi-Fi temperature sensor used to measure temperature in swimming pools, SPAS, aquariums and fish ponds.
The sensor uses the IBS (Intelligent battery saving mode) module that ensures long battery life.
It is automatically adjusted for temperature change, so a large change automatically switches the communication to one minute. If the temperature is stable, the communication point is extended to 10 minutes.
If the battery capacity falls below 30%, IBS will automatically fix a 10-minute period.
The water temperature in the pool does not change much in 10 minutes, but if you want the IBS to change the period, change the batteries when they drop below 30%.
Battery capacity is sent with each measurement.
You can set an alarm for low battery level (default is 10%) which is sent to you by email or SMS (depending on what you put in the Send to box)
Warning: Do not insert batteries with the opposite polarity! The battery will be short-circuited, heat up and may explode.
Instruction:
How to connect your device to T-One
This device belongs to IoT device technology.
If you are not sure which Wi-Fi router you have, see the following document before ordering: Frequent problems with the router
Attention: "Smart Wi-Fi technology" does not work properly with IoT devices and you need to separate the 2.4 and 5 MHz networks. Read this article.
Note: if you insert batteries, you must immediately configure the device to connect to your Wi-Fi.
If, for some reason, you can't connect the device to your Wi-Fi and want to do so tomorrow, remove the batteries as they will be much more charged while you set up the connection.
If you do a factory reset, you have to reconfigure the connection with your Wi-Fi because everything is deleted.
 |
 |
 |
 |
|
Where to buy it:
|
